Carbide cutter cone green Fréza pro NailArt

Hard metal milling cutter cone green narrower

Carbide Wolfram cutter - coarser

Carbide ( carbide) cutter designed for professional use only.

Thanks to the fine blades and rounded cone ends, the cutter is suitable for gentle removal of old modelling and for adjusting the final shape of smaller nails.

Undercutting the nail with this cutter is easier thanks to the single cross-cut cutting edge and the narrower version gets you where you need to go faster. You will appreciate it when unwanted hardening of excess gel from the bottom of the nail when working with Dualform.

Also suitable for pedicurists.

Cutter with high durability.

Shank diameter- 2,35 mm

Blade length- 13mm

Blade diameter- 4,0mm

Proper use of rotary tools (cutters) for manicure:

Warning! Observe the max. speed! 15- max. 25k rpm

For each rotary tool it is necessary not to exceed the maximum speed specified by the manufacturer.

Exceeding the maximum speed will damage the clamping mechanism!

Too much pressure on the cutter overloads the micromotor in your grinder, the clamping device in the hand piece, but also the cutters. Therefore, insert the cutters sensitively into the chuck and work carefully without too much pressure. The cutters thus become less clogged and the grinding ability is not reduced. After grinding it is necessary to clean the milling machine from dirt mechanically with a dust brush (with a special metal cleaning brush if necessary - you can also find it in the offer) and sterilise and disinfect with products intended for metal tools.

The sterilization temperature during hot air sterilization must not exceed 180°C.

Exceeding this temperature leads to a loss of hardness and thus a reduction in tool life.